Angle Copier TC133R by Virutex Arm Puller Finely ground with a straight

Finely ground with a straight cutting edge to cut bricks without damaging them

allowing for operation in tight or hard-to-reach areas with minimal additional setup required

Guide rail adapter for use with the OF 1400 routers in combination with the FS guide rail system

with its focus on accuracy

Slotted Clamp Bar

Angle Copier TC133R by Virutex Arm Puller Finely ground with a straightAngleCopy gives the correct angle when making matering cutters. Without to take measurements and without to loose time making complicate calculations, AngleCopy is very practice for copying angles different than 90. When copying the desired angle with AngleCopy, the cutting guide divides the angle in two, giving the exact position for the miter cut. It is also provided with a small knob to fix the copied angle and to avoid mistakes when transferring