CRL Brushed Stainless UV Glass-to-Glass Cone Hinge - 15/16" (24 mm) Cone Tripple-Ripple Plated Diamond Drill Bits 90° Manual Tilt

90° Manual Tilt

apply slight pressure on center of follower plate while pumping dispenser to eliminate trapped air

Available Cutting Heads:

the sealant reacts with atmospheric moisture to produce a low-modulus

The heavy-duty top hinge uses 10 steel rivets on each side for long-lasting strength and durability

CRL Brushed Stainless UV Glass-to-Glass Cone Hinge - 15/16" (24 mm) Cone Tripple-Ripple Plated Diamond Drill Bits 90° Manual TiltFor Inset or Overlay Doors Available in Two Sizes CRL's UV Cone Glass to Glass Cone Hinges are designed for all glass showcases with inset or overlay doors. The doors must overlap the end of the glass side panels by 1" to 2" (25 to 50 mm) depending on which Hinge is being used. The Hinges are bonded on exterior end panels and the overlap portion of the glass door. The Hinges open to a maximum of 180 degrees. Fabricated in brushed stainless steel.