014-1066-050 - Follower plate for industrial pumps with shank 50 mm subgroup-Accessoires en losse onderdelen-Vet oplossingen for medium-long distances (150 200

for medium-long distances (150 200 m)

To optimize the performance and the time-life of the air-operated pumps advise to use filtered and lubricated air

Inlet : F1/4"G

The operating pressure of the pumps can vary between a minimum of 3 bar and a maximum of 8 bar

They can be used to transfer huge quantities of lubricants at medium pressure

014-1066-050 - Follower plate for industrial pumps with shank 50 mm subgroup-Accessoires en losse onderdelen-Vet oplossingen for medium-long distances (150 200It is advisable to use always the follower plate. it is very important of ambient temperature is low and when high viscosity grease is used. Because of the depression created by the pump. the plate is attracted towards the bottom of the drum by atmospheric pressure. It pushing the grease into the pump and avoids air cavities. Also it removes the grease remaining on the walls down to the bottom of the drums.